Turnigy 130A

Discussion in 'General Questions' started by rake1, Dec 12, 2012.

  1. rake1

    rake1 WindyNation Engineer

    I have a new xantrex c35 charge controller that doesn't have a display. I was wondering if my Turnigy 130a could be set up to display the output from this controller, I bought this and never used it but don't know if it is designed to do this . http://www.hobbyking.com/hobbyking/s...dProduct=10080
    It didn't show the same numbers as my clamp meter and my trimetric diplay. I put the source on the windmill or solar array and the load on my battery bank. Any ideas as to why I couldn't get the amps( in particular) to show the same as the other meters
  2. rake1

    rake1 WindyNation Engineer

    No thoughts on this one guys
  3. leamywind1

    leamywind1 WindyNation Engineer

    Yes it can. Can you show how you wired it on a diagram or video? Are you using the Turnigey for solar or wind, or is your solar and wind tied together as one system?

Share This Page