My old Induction Motor Conversion setup

Discussion in 'Windtura Generators' started by timber, Nov 9, 2010.

  1. timber

    timber WindyNation Engineer

    Several times I've made reference to my Induction Motor Conversion/ Alternator.
    The following is a link to the setup that I had.
    This alternator is now on the ground and in my shop for a rebuild.
    I'll be replacing it with a Windtura 500 Starter Kit with home-built frame and furling tail.
    Once the conversion is rebuilt (may replace the existing neos with some larger ones), new bearings etc.) I'll have two motors in the air.
    Picture the addition of a new Coleman Air C80 charge controller, diversion load and different battery bank and some changes to wiring.
    I'll install a new tilt-up pole at the opposite end of the lot. (Pictures are not the greatest but should give you an idea of my humble system.) ... 708.0.html


Share This Page