240vac wiring question

Discussion in 'Wiring Methods' started by TimH, Jul 4, 2013.

  1. leamywind1

    leamywind1 WindyNation Engineer

    Sorry to hear. In a nut shell. It runs on 50htz instead of 60?
    Are you now up and running with your re programing?
    Yes...you get what you pay for. I just hooked up an SMA today, and they are very nice.
    Thanks for being honest and open.
     
  2. The GTI defaults are 50hz, and for some odd reason the GTI's config was lost and so it went into fault mode because the frequency was outside the normal safe range (it was expecting 50hz and I'm in Massachusetts which is 60hz). It's back up and running once again after I reconfigured it, the support at KLNE was responsive but because they are based in China it takes a day to get a response then they ask for more info and I respond and wait another day, etc.
     
  3. leamywind1

    leamywind1 WindyNation Engineer

    Ok cool so you made progress. You would think they would set the default for 60Hz since it is coming to the US I hope it works out for ya. Good luck and thanks for the response
     

Share This Page