Was at the cabin site this weekend. Ohmed every thing out with a better meter, still a dead phase. Checked all connections, and removed the...
My cheapo harbor frieght voltmeter isn't measureing resistance for some reason. I will have to troubleshoot this next time I'm at the site in a...
Just installed my Windtura 750. Wind is only about 8mph but enough to see AC voltage across 2 of the phases. But one phase is dead. Voltage...
Good advice. I will slide that anemometer down a bit. It sticks out about 16" or so but not sure. Will check when its down.
Here's a couple pics of what I did. Ground down that seem on the sleeve so it doesn't grind out my tower pipe after years of movement. Added zerk...
I'm heading up to the cabin site next Thursday to install the turbine. Probbaly not enough time for the adapter. I'm painting it all dull brown...
I've been looking for a ~4ft piece of Sch80 pipe for a week now. All I've found is special ordering a 21ft piece for couple hundred bucks. So...
OK thanks. I assume that 29amps is using a clamp on one leg.
I'm ready to buy the 24V 750 but can't until I get some specs on the AC output of the PMA. What's the max Voltage and Current across 2 of the...
So I see the 24V 750 model can max at ~1100w equaling ~ 45amps. I assume this is measured after the rectifier on the DC side. So what is the...
Yep, this my first tower. I found some 3/16 (7x19) Galv cable rated to 840lbs. Will use that and start at 28ft tall and raise it later if needed....
Separate names with a comma.
